William Optics + Player One
Zenithstar 61 with the Poseidon-C Pro
between the corrector and the sensor, for 56.0 mm of back focus.
38.5 mm of spacers puts the Zenithstar 61 with the Poseidon-C Pro exactly on target.
Assumes the William Optics FLAT 61R (0.8× reducer) between the two.
The imaging train
Where this number comes from
The William Optics FLAT 61R does not have a single back focus figure — it depends on the telescope it is fitted to. On the Zenithstar 61, William Optics specify 56.0 mm. That is the distance from the back of the corrector to your sensor, and it is what everything below is working towards.
The Poseidon-C Pro contributes 17.5 mm of that on its own — sensor to front face — which leaves 38.5 mm for spacers.
30.0 mm + 7.5 mm + 1.0 mm comes to exactly 38.5 mm, so this combination lands on target with nothing left over.
What to buy
| Part | Length | Threads |
|---|---|---|
Apertura M48 Extension Spacer Ring 30mm BuyHigh Point Scientific · US | 30.0 mm | M48 |
Baader M48 extension tube 7.5mm BuyAlpine Astronomical · US | 7.5 mm | M48 |
Astrodymium M48 fine adjustment ring 1.0mm BuyAgena Astro · US | 1.0 mm | M48 |
| Corrector to camera | 38.5 mm | 56.0 mm − 17.5 mm camera = 38.5 mm needed |
Links to retailers are affiliate links. They cost you nothing and they pay for this site. They do not affect which parts are recommended — the stack above is whatever lands closest to target.
What you get
- Focal length
- 288 mm at f/4.7 (from 360 mm native)
- Sampling
- 2.69″/px
- Field of view
- 4.67° × 3.12°
- Sensor
- 23.5 × 15.7 mm, 3.76 µm pixels
Where to buy this setup
Where to buy the Player One Poseidon-C Pro
Affiliate link — they may earn this site a commission and change nothing above. No prices shown: this site is static, and a stale price is worse than none.
Read next
Sources and caveats
Player One specify "Back Focal Length 17.5mm, 12.5mm( without sensor tilt plate)" for the Poseidon-C Pro, measured to the camera's own front face with no adapters fitted.
We have not recorded the thread gender of every part listed above. The lengths are right; check that the faces actually mate before ordering.
Every figure on this page was read from the manufacturer’s own documentation and last checked in September 2026. Manufacturers revise them — ZWO and QHY both have, mid-model — so that date is part of the answer.
Check these figures against your own manuals before buying. If something here is wrong, tell us and we will fix it.
Measuring your own? The four tools worth owning for this →