Sky-Watcher + Player One
Evolux 62ED with the Artemis-C Pro
between the corrector and the sensor, for 55.0 mm of back focus.
37.5 mm of spacers puts the Evolux 62ED with the Artemis-C Pro exactly on target.
Assumes the Sky-Watcher 0.9x Reducer/Flattener for Evolux 62ED (0.9× reducer) between the two.
The imaging train
Where this number comes from
The Sky-Watcher 0.9x Reducer/Flattener for Evolux 62ED wants 55.0 mm between its rear shoulder and the sensor.
The Artemis-C Pro contributes 17.5 mm of that on its own — sensor to front face — which leaves 37.5 mm for spacers.
30.0 mm + 7.5 mm comes to exactly 37.5 mm, so this combination lands on target with nothing left over.
What to buy
| Part | Length | Threads |
|---|---|---|
Apertura M48 Extension Spacer Ring 30mm BuyHigh Point Scientific · US | 30.0 mm | M48 |
Baader M48 extension tube 7.5mm BuyAlpine Astronomical · US | 7.5 mm | M48 |
| Corrector to camera | 37.5 mm | 55.0 mm − 17.5 mm camera = 37.5 mm needed |
Links to retailers are affiliate links. They cost you nothing and they pay for this site. They do not affect which parts are recommended — the stack above is whatever lands closest to target.
What you get
- Focal length
- 360 mm at f/5.8 (from 400 mm native)
- Sampling
- 2.65″/px
- Field of view
- 3.06° × 2.07°
- Sensor
- 19.2 × 13 mm, 4.63 µm pixels
Where to buy this setup
Where to buy the Sky-Watcher Evolux 62ED
Affiliate link — they may earn this site a commission and change nothing above. No prices shown: this site is static, and a stale price is worse than none.
Where to buy the Player One Artemis-C Pro
Affiliate link — they may earn this site a commission and change nothing above. No prices shown: this site is static, and a stale price is worse than none.
Where to buy the Sky-Watcher 0.9x Reducer/Flattener for Evolux 62ED
Affiliate links — they may earn this site a commission and change nothing above. No prices shown: this site is static, and a stale price is worse than none.
Read next
Sources and caveats
Player One specify "Back Focal Length 17.5mm, 12.5mm( without sensor tilt plate)" for the Artemis-C Pro, measured to the camera's own front face with no adapters fitted.
We have not recorded the thread gender of every part listed above. The lengths are right; check that the faces actually mate before ordering.
Every figure on this page was read from the manufacturer’s own documentation and last checked in September 2026. Manufacturers revise them — ZWO and QHY both have, mid-model — so that date is part of the answer.
Check these figures against your own manuals before buying. If something here is wrong, tell us and we will fix it.
Measuring your own? The four tools worth owning for this →